This post contains affiliate links. Affiliate links help me earn a commission so that I can continue to bring you great content. Affiliate links are of no cost to you.
This is the first flight controller of its kind supporting both onboard DSMX and BetaFlight OSD for the Tiny Whoop form factor. This flight controller has everything you need and is great for anyone using a Devo or DSMX compatible transmitter.
Here are the full specs of the flight controller.
ESC: All FETs are rated at 6.3A maximum
Size: 26mm x 26mm,fully compatible with the Inductrix quad frame and mounting pattern
Firmware version:Betaflight BETAFLIGHTF3
OSD: Built-in BetaFlight OSD (STM32 controls OSD chip over SPI in DMA mode)
Receiver: DSMX potocol (SBUS)
Power Cable: 55mm, with JST-PH 2.0 connector, AKA PowerWhoop connector
1 * F3 OSD brushed flight controller with DSMX receiver ( 55mm PH-JST 2.0 power cable soldered)
4 * M1.2x4mm screws (Fit for stock Inductrix frame)
4 * M1.4x5mm screws (Fit for Beta75 etc 75mm frame)
4 * Anti-vibration ruber dampers
1 * 55mm PH-JST 1.25 power cable pigtail
Pick one up today.
This flight controller is compatible with a ton of frames. Here are just a few
Betafpv 65 frame
Betafpv 75mm frame
Stay tuned for a build video and Devo setup video coming soon.
Thank you very much for watching.
Thank you to BetaFPV for sending me the flight controller.
Like, Share & Subscribe
Fly Safe and Fly Often