Hello everyone welcome back.
In today’s video I will be showing off a new build I have been working on.
This is the BetaFPV 83. I have upgraded the frame from 65mm to 83mm. I was able to get it flying really well after some tweaks. I ended up soft mounting the flight controller using a combination of plastic washers and rubber bushings. This cleared up my issues with pitch and roll drift. I did have to adjust the flight controller orientation due to the layout of the new frame. I used 180 for roll and 35 for yaw.
Here are the full specs for the build
BetaFPV 83mm Carbon Fiber Frame
Recommend motors: 1102 1103 1104 brushless motors
Form Factor: 16mm x 16mm
BLHeli 6Amp 4 in 1 ESC
Form Factor: 16x16mm
Input voltage: 2S lipo
Con. current: 6A
Peak current: 10A (5S)
Processor: SILABS EFM8BB21F16G
Driver: 3 in 1 MOS
Omnibus F3 Flight Controller
Form Factor: 16*16mm
Processor: STM32F303CCT6 (72MHZ, 256K FLASH)
Sensor: MPU-6000 (connected by SPI)
Power supply: 2S lipo battery ( 6.5V-8.4V)
BetaFPV 1103b 10,000kv Brushless Motors
Weight: about 3.7g
No longer available via BetaFPV. Here are some 7600KV motors.
1103 7800KV Brushless Motors
BetaFPV 1735 4 Blade Props
Material: PC plastic
Length: 1.7 inch, about 43.2mm
Color: white, orange, purple, green, blue, red
Mounting hole: 1.5mm
Weight: 0.8g per piece
Applicable for 1102, 1103, 1104, 1105, 1106, 11xx motors
BetaFPV H01 AIO FPV Camera
Output power: 25mW
Supply Voltage: 2.9-5.5v
Frequency: 5.8GHz 40 Channels
If you have any questions about this build feel free to leave me a comment.
Dont forget to enter to win the BetaFPV 65s Frame Kit Giveaway.